Generally, the porch area of the houses is left unsheltered just for the sake of calmness and serenity. However, the situation may reverse for the households that are located in extreme habitats. The nature could hurt the structural integrity of your porch architecture without any protective shield over the area. In fact, the porch areas are considered inappropriate for proper sheltering.

The unsheltered porch areas could survive in the areas which maintain a moderate temperature around the year. However, extreme weather conditions could hurt the porch area badly. For instance, the plants and vegetation cover would fail to survive under the extreme heat of the sun. The tissues of the plants would burn out due to excessive heat. In a similar manner, the rainfall or hailstorms would damage the items placed in the porch area. Arrange your tools and required roofing supplies if you wish to protect your porch area from such irregularities.

Start off by evaluating the structure of the new roof. Plan a rough layout of the roof architecture and note down the supplies that would be required during the project. The posts of the new roof need to be installed on the ground. Hence, tag the spots where the support posts for the new roof would be rooted.

Take out a digging tool from the kit and star digging the spot on the ground. The depth of the hole should complement the strength of the roof foundation. A depth of at least 18 inches is considered appropriate for the standard roofs. Mix a little amount of water in cement and pour the prepared mixture in the holes. Do not forget to plant a bolt that comes with the package of the support base. Allow the setup to rigidify and inspect the setting once again after 24 hours. Once the cement setup has solidified, install a bracket over the existing bolts. Furthermore, attach the support posts to the respective brackets one by one.

Remove the length of the support posts that are not required in the setup. The length of the posts must reach the base of the roof cover. Ensure your own safety while cutting the support posts.

Construct the network of frames and trusses that would act as the foundation for the roof cover. Next, place a plywood or OSB layer on the trusses.

Attach a drip edge and install the shingles one by one on the roof area.

Paint and stain the roof to render finishing touch to the whole setup.

Scott Rodgers is a fine expert who has been authoring on roofing contents for a long time now. His unique guidance has given motivation to a host of workers, ranging from Port Townsend Roofers (Need one? click here!) to Vaughn Roofers (Need one? click here!).